All customers except US A&D: to ensure that you can access all of your product downloads, you must log in to the Wind River Delivers portal and visit the My Products page to force an initial sync of your product entitlement. Only after you’ve completed this step will you be able to access and download product content through the Artifacts, Registry, and Git interfaces. This also applies to users attempting to run the Wind River installer in maintenance or update mode or Linux installation updates at the command line.

Wind River Support Network

HomeOther DownloadsPNE-LE 2.0: binutils fails to build
Recommended Type: Patch

PNE-LE 2.0: binutils fails to build

Released: Dec 17, 2008     Updated: Dec 17, 2008


/home/cso/W2.0/berger/tst2/tst4/build/binutils-2.17.50/binutils/ar.c:142: undefined reference to `yyparse'

collect2: ld returned 1 exit status

make[5]: *** [ar] Error 1

make[5]: Leaving directory `/home/cso/W2.0/berger/tst2/tst4/build/binutils-2.17.50/binutils'

make[4]: *** [all-recursive] Error 1

make[4]: Leaving directory `/home/cso/W2.0/berger/tst2/tst4/build/binutils-2.17.50/binutils'

make[3]: *** [all] Error 2

make[3]: Leaving directory `/home/cso/W2.0/berger/tst2/tst4/build/binutils-2.17.50/binutils'

make[2]: *** [all-binutils] Error 2

make[2]: Leaving directory `/home/cso/W2.0/berger/tst2/tst4/build/binutils-2.17.50'

make[1]: *** [all] Error 2

make[1]: Leaving directory `/home/cso/W2.0/berger/tst2/tst4/build/binutils-2.17.50'

make: *** [binutils.compile] Error 2

make: Leaving directory `/home/cso/W2.0/berger/tst2/tst4/build'




Product Version

Linux Platforms 2.0


Installation Notes

Installation Notes is for 2.0

1. Unzip this patch under [install_dir]/updates        

2. From the [install_dir]/updates directory, run the command "../maintenance/mtool/mtool_linux"    

3. Follow the instructions for installing the point patch.    

4. This is a source only patch so you will have to rebuild the package. This can be done by executing the command "make -C build linux.distclean" followed by "make -C build linux.rebuild"    

5. Run "make fs" next    

6. Upload the kernel and rootfs into the target and boot it up.

Live chat