All customers except US A&D: to ensure that you can access all of your product downloads, you must log in to the Wind River Delivers portal and visit the My Products page to force an initial sync of your product entitlement. Only after you’ve completed this step will you be able to access and download product content through the Artifacts, Registry, and Git interfaces. This also applies to users attempting to run the Wind River installer in maintenance or update mode or Linux installation updates at the command line.

Wind River Support Network

HomeOther DownloadsMerge vmc_SB_fix.patch
Recommended Type: Patch

Merge vmc_SB_fix.patch

Released: Oct 8, 2008     Updated: Oct 8, 2008


When a sensor asserts, a SEL would be created to describe such event, and it
would be inserted to vMC SEL Repository(and written to PMEM if supported).
If CONFIG_IPMI_VMC_ENABLE_IPMB is enabled, then vMC would send a msg to BMC
as well.

On all BSPs except IXDP2801 vMC would send message to BMC itself, while on
IXDP2801 BMC would bridge vMC message onto IPMB.

This patch makes clear the type of bmc_addr in bmc_private structure to be
ipmi_ipmb_addr for IXDP2801, whereas ipmi_system_interface_addr for all the
rest of BSPs. And only ipmi_ipmb_addr type has member of slave_addr.

Product Version

Linux Platforms 1.x


Installation Notes

Installation Notes is for 1.4

1. Unzip the patch under [install_dir]/updates

2. Install the patch CD by entering the patch CD directory and run setup_linux.

3. This is a source only patch so you will have to build the kernel

4. Issue a make fs and make the kernel in a configured directory.

5. Upload the kernel and rootfs into the target and boot it up.

Live chat