All customers except US A&D: to ensure that you can access all of your product downloads, you must log in to the Wind River Delivers portal https://delivers.windriver.com and visit the My Products page to force an initial sync of your product entitlement. Only after you’ve completed this step will you be able to access and download product content through the Artifacts, Registry, and Git interfaces. This also applies to users attempting to run the Wind River installer in maintenance or update mode or Linux installation updates at the command line.

Wind River Support Network

HomeOther Downloadskprobes on PPC64
Optional Type: Patch

kprobes on PPC64

Released: Dec 7, 2008     Updated: Dec 7, 2008

Description

Kprobes on PPC64 are registered by never triggered when built against PNE-LE 1.4 on the mot_atca6101. The example is from Documentation/kprobes.txt, but modified to print the register set from PPC64 rather than IA32.


kern.log:

Mar 4 23:00:40 atca6101 kernel: Module sctp cannot be unloaded due to unsafe usage in net/sctp/protocol.c:1174 Mar 4 23:00:40 atca6101 kernel: Software Watchdog Timer: 0.07 initialized. soft_noboot=0 soft_margin=60 sec (nowayout= 0) Mar 4 23:00:40 atca6101 kernel: ipmi message handler version 36.0 Mar 4 23:00:40 atca6101 kernel: ipmi device interface Mar 4 23:00:41 atca6101 kernel: IPMI System Interface driver.

Mar 4 23:00:41 atca6101 kernel: ipmi_si: Trying "kcs" at I/O port 0xca2 Mar 4 23:00:41 atca6101 kernel: ipmi_si: Trying "smic" at I/O port 0xca9 Mar 4 23:00:41 atca6101 kernel: ipmi_si: Trying "bt" at I/O port 0xe4 Mar 4 23:00:41 atca6101 kernel: ipmi_si: Unable to find any System Interface(s) Mar 4 23:00:41 atca6101 kernel: IPMI Watchdog: driver initialized Mar 4 23:00:45 atca6101 kernel: eth6: no IPv6 routers present Mar 4 23:01:56 atca6101 kernel: kprobe registered IDENTIFIER = WIND00101574


Product Version

Linux Platforms 1.x

Downloads


Installation Notes

  1. Unzip the patch under [install_dir]/updates

  2. Install the patch CD by entering the patch CD directory and run setup_linux.

  3. This is a source only patch so you will have to build the kernel

  4. Issue a make fs and make the kernel in a configured directory.

  5. Upload the kernel and rootfs into the target and boot it up.


Live chat
Online