Wind River Support Network

Description

The following defect(s) have been fixed in this cumulative patch for the Wind River Wrll-imx27_board_3.1

WIND00134537  WR linux2.0 : Incomplete OTG USB drivers for iMX27ADS

---

Product Version

Linux Platforms 2.0

---

Downloads

---

Caveats

Requires Wind River Linux 2.0 Service Pack 3 (2.0.3) to be installed.

---

Installation Notes

Installation Notes

1) Unzip this patch under [install_dir]/updates
2) From the [install_dir]/updates directory, run the command "../maintenance/mtool/mtool_linux"
3) Follow the instructions for installing the point patch.
4) This is a source only patch delivered as a layer so you will have to rebuild your platform project. This can be done by executing:
..WRLinux_Install_PATH../wrlinux-2.0/wrlinux/configure --enable-board=fsl_imx27ads --enable-kernel=small --enable-rootfs=glibc_small --with-layer=wrll-imx27_board_3.1
5) Next execute "make -C build linux" to build the Linux kernel
5) Run "make fs" 
6) Upload the kernel and rootfs into the target and boot it up

 

 

 

Caveat: Adding "--with-layer=wrll-imx27_board_3.1" to the configure command is needed for using OTG HS on port J9 (see the updated BSP's README for further details).

---